Welding truck, service truck. With welder

Its an 83 f250 2wd. 6.9 diesel. Had a reg bed on in, was all diff colors, single rear wheel.. I bought the service bed and put it on. Its got all underneith off a 97 f350 dually. Sterling rear end with a strong limited slip. Dually. The 97 front i beams. All new rotors and brakes all around. New drums and pads and wheel cyls innthe back. New drive line and u joints. Its got a 4" lift, with drop brackets from a f150 same year. And 6.0 coil springs. Rides good and level. Rear has air bags too. Auto trans. Its got a fresh paint job, shines like a mother. Very very good tires. Moto metal rims. The seat inside is from the 97, better. Runs good, but needs glow plugs. Doesnt like to fire when its cold out. Some of the plugs are mushroomed, so the heads gotta come off. Its a simple push rod motor no turbo, easy. $100 in gaskets. Ive been building this truck and lost interest. Needs mirrors, rear tail lights for the bed. Shocks. Stuff like that. Runs and drives great. Pump has been turned up. Oh and the exhaust is cut under the cab, so, run some flex pipe.. the welder is a PandH 200. same thing as an sa200. Has the continental flathead, runs like a top and welds great. It too, could us a little love. Fresh black paint job. Reall the only thing, the face plate is hard to read. And it stays reved up. Wont idle down.. so, gotta figure that out. But it fires right up and runs smooth. Clean title pink in hand $3500 including welder