1931 Ford Model AA 1.5 ton Truck

1931 Ford Model AA 1.5 ton truck. The pictures are of the truck, but the cab, doors, hood, bed, no longer are on it (different hood, and a cowl with fuel tank were swapped on) and the wheels/tires are different. There is no cab roof, cab back, or doors, and no truck bed. The current hood is pretty rough but works, has a cowl in rough shape, and the fuel tank that holds fuel without leaking. I will work on getting new pictures. Currently only has a single set of wheels in the back (they are the dually style wheels). Radiator is in good shape (new top tank just installed) for the age and holds coolant and keeps the engine cool. The are NO coolant leaks and has new antifreeze in it. This is the short wheel base version. Rear axle is 5.14:1 gear ratio. This is a good start to a project with a good solid drive train (complete motor, tranny, etc), cooling system, etc. I have a Jeep rear seat I have been using for it. Find a good cab/parts and keep putting it together (I have a project cab also available...). The frame doesn’t have any rust pitting and is all painted. The truck has been inside in clean dry storage for the last 40 years as a project. The engine was run frequently to keep it maintained. It was rebuilt recently but do not have documentation. The transmission is the 4 speed with the PTO port on the passenger side (no cracks like most of them do). I do not have the title, but I can apply for one. New/just installed: -Stainless radiator rods -Stainless lower radiator tube -Coolant hoses and clamps -Water pump (leakless upgraded one) −4 bladed fan -Distributor -Rear axle and spring eyes rebushed, pinned, and new grease fittings -New gear oil through out (removed and cleaned u-joint housing, regasketed and new felt seals) -New bushings in pedals -New fuel shut off valve and «rebuilt» the sediment bowl -Steering box regasketed -New radiator and grill shell hardware -New bumper and apron hardware -New fuel lines -New exhaust clamp at the manifold What it needs: -Cab back, roof, and doors (I have these parts available for extra if they are something you are interested in, but rough shape) -Fenders, running boards, brackets (also have a selection of these depending on what you want, but rough shape) -Light bar (have some in rough shape/bent) -Seat -Glass -Floor boards -Tires/wheels −6V battery -Muffler This truck runs VERY well, drives, stops (all 4 wheels are working), e-brake works, charging system works, doesn’t overheat, steering is tight,